Wobbler XF1728-05 1/2″ For Irrigation System

Short Description:


  • Item: XF1728-05 1/2"
  • Size: 1/2"M
  • Working Pressure: 0.69-1.72bar
  • Flow: 177-1583L/H
  • Qty/CTN: 100
  • Vol./CTN: 0.0404
  • Country: China
  • Nozzle diameter: 2.38mm,2.78mm, 3.18mm,3.57mm, 3.97mm, 4.37mm, 4.76mm,5.16mm, 5.56mm
  • Product Detail

    Product Tags

    Greenlake Irrigation Manufacturer  only sells to irrigation dealers and does not sell direct to end users.

    Flow: 0.8-1.2 GPM, Diameter: 36.4-46 feet, Pressure: 10-25 PSI. The Xcel-Wobbler uses Senninger’s off-center rotary-action technology. It provides an extremely uniform and instantaneous application pattern over a large area at lower pressures, and with very low evaporative loss.

    Features:
    Counter-balance reduces vibration for a smooth, stable performance
    Only one moving part – which translates to longer life
    Operating pressures: 10 to 25 PSI
    Low wind drift and evaporative loss at low pressures
    Color-coded nozzles for easy size identification

     Guide for Wobbler

    In this guide, we will cover the 4 main factors to consider when selecting a wobbler for your application. The four factors are:

    1. The flow rate (GPM) you want to supply with each unit

    2. The coverage area needed per unit (measured in feet)

    3. The pressure (PSI) required by the system for optimal performance

    4. The application it will be installed in (inverted, indoor, outdoor…etc).

    To begin, here is a flow rate chart of the different wobbler models and their corresponding flow rates:

     

    Flow rate is important to consider for a few reasons; one being the plants in your system will require a specific amount of water (you’ll want to make sure you aren’t providing too much or too little water), and two; the water source you are using will be limited to the maximum flow rate it can supply. (This is important because if the required volume of water from the system is higher than the volume of water supplied by the water source, you will need to zone your system to avoid overtaxing your water source).

    Second is the coverage area. This is the wetted area provided per unit. Here is a quick diagram showing the different wobbler models and the maximum and minimum coverage areas offered.

    Please note, the coverage area can vary depending on the nozzle used and the operating PSI of the system.

     

    In determining the coverage area per each wobbler, it will also be important to consider the spacing between the units.


  • Previous:
  • Next:

  • Write your message here and send it to us